Haier 102102429 User Manual - Page 27

Maintenance Service and Trouble Shooting a) Check the input power circuit to see whether where is voltage of the power supply, namely, the circuit which is connected to the knife switch. This can be determined with an avometer or a test pencil. If a blown fuse is found, ascertain and remove its cause, then replace it with a new one of the same specifications. b) Check the compressor accessories, including its thermal protector and relay. In case the thermal protector is damaged, the compressor cannot be powered on. If the relay is out of order, the motor will not run and hum sound can be heard from it after the compressor is turned on, in that case, shut it down immediately, otherwise, the motor windings will be burned out in case this condition lasts longer. c) Check the relay contacts and plugs to see if they are perfect and work reliably. Poor contact may cause the motor not running or humming. 2) Check the circuit voltage to see whether it is normal. Analysis of trouble If the circuit voltage is obviously lower than its rated value, it will be difficult to start the motor, and a hum sound can be heard from it. Remedy Measure the voltage with a voltmeter, if it is really too low, give directions to the user for buying a stabilizer so as to step up the voltage, thus normal operation can be achieved. 3) Check the thermal relay to see whether its contacts are closed. Analysis of Trouble The contacts of thermal relay sometimes may be open due to the leakage of temperature sensing agent from the temperature sensor. Remedy Remove the relay cover to check up its contacts, if they are open, this means that the original setting is not properly set or temperature sensing agent has leaked out of the temperature sensor. Try to turn the adjusting stem of this value in the direction of the lower temperature graduation, then check the contacts to see whether they are closed. If they are still not closed, dismantle the temperature sensing disc and then immerse it into warm water to see whether the contacts actuate, if not, it can be preliminarily determine that temperature sensing agent has leaked out, and it must be replaced with a new thermostat. 4) Motor troubles and other electric faults a) Motor windings have been burned or short-circuited between turns Analysis of Trouble When motor windings have been burned or short-circuited between turns, the fuse will be blown repeatedly, and the blowout occurs particularly at the instant when you close the knife switch. Remedy Check the terminals and the outer casing to see whether they are short-circuited, and measure the resistance of each phase with an 27