Haier 2HUM14HC03 User Manual - Page 2

Parts and Functions Indoor Unit Remote controller 1 8 2 3 4 5 6 7 1 Inlet 6 Display board 2 Inlet grille 7 Emergency Switch 3 Outlet 4 Vertical blade 8 Air Purifying Filter (inside) (adjust left and right air flow) 5 Horizontal flap (adjust up and down air flow. Don't adjust it manually) Please be subject to the actual produce purchased the above picture is just from your reference Outdoor Unit 4 OUTLET CONNECTING PIPING AND ELECTRICAL WIRING INLET  DRAIN HOSE Please be subject to the actual produce purchased the above picture is just from your reference Clock set Press CLOCK button, "AM" or "PM" flashes. Press or to set correct time. Each press will increase or decrease 1min. If the button is kept pressed,time will change quickly. After time setting is confirmed,press SET, "AM "and "PM" stop flashing,while clock starts working. TIMER POWER/SOFT CLOCK LIGHT SET LOCK SLEEP RESET 2 1 10 6 2 7 5 8 3 9 ON/OFF 4 11 13 FAN 18 MODE SWING 15 TIMER POWER/SOFT 23 12 20 21 CLOCK 14 LIGHT 19 SET SLEEP 16 17 22 LOCK RESET 1. Mode display Operation mode AUTO COOL DRY HEAT FAN Remote controller 2. SWING display 3. FAN SPEED display AUTO LO MED HI 4. SLEEP display 5. LOCK display 6. SIGNAL SENDING 7. TIMER OFF display 8. TIMER ON display 9. CLOCK display 10.TEMP display 11. POWER ON/OFF button 12. MODE button 13. FAN button 14. HOUR button 15. SWING button 16. SLEEP button 17. LOCK button Used to lock buttons and LCD display. 18. TEMP.SETTIN button 19. SET / LIGHT button 20. TIMER button 21. CLOCK button Used to set correct time. 22. RESET button When the remote controller appears abnormal, use a sharp pointed article to press this button to reset the remote controller normal. 23. HOUR / POWER/SOFT button Used to set clock and timer setting. Every time the button is pressed, display changes as follows: BLANK POWER SOFT Loading of the battery 1 Remove the battery cover; 2   Load the batteries as illustrated. 2 R-03 batteries, resetting key  (cylinder); 3 Be sure that the loading  is in line with the" + "/"-"; 4 Load the battery,then put on the cover again. Note: The distance between the signal transmission head and the rece- iver hole should be within 7m without any obstacle as well. When electronic-sta rted type fluorescent lamp or change- over type fluorescent lamp or wireless telephone is installed in the room, the recei ver is apt to be disturbed in receiving the signals, so the distance to the indoor unit should be shorter. Full display or unclear display during operation indicates the batteries have been used up.Please change batteries. If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later. Hint: Remove the batteries in case won't be in use for a long period. If there is any display after taking-out, just press reset key.