Haier AB092FEAIA User Manual - Page 12

Operation Guide Display All content that can be shown on the display of remote controller are listed here to describe in details. In practical use, only content selected can be shown. 1 Switch over of fan speed Showing fan speed mode selected Indoor unit Display of FAN Duct type Types other than of duct type FIX AUTO HIGH MED LOW 2 Running mode Showing selected running mode 3 Temperature setting Showing selected temperature setting 4 check Showing code of failure shooting Showing number of indoor unit with fault in display part of temperature setting MODE FAN ONLY COOL HEAT FAN AUTO HIGH MED LOW FIX CENTRAL OPERATION STANDBY PREHEAT DEFROST FILTER TEMP UNIT CHECK LOUVER DEMAND MANUAL çC çF TEMER CONT.OFF ON ADDRESS AFITER H M 5 TIMER If timed running is set, display parts of ìpower onî and ìpower offî will show ì TIME ON î and ì TIME OFF î. If timed running is changed to continuous, ì CONT î will display momentarily then goes out. Display of ìCENTRALî 6 Operation Showing in operation. 7 Stand by This is displayed when the machine can not run as set mode while multiple in door subassemblies are running 8 Preheating,defrost This is displayed when preheating or defrosting. 9 Filter Clean air filter when this is displayed. 10 Central This is displayed when using central controller for central control mode. 11 Louver Showing automatic swing. 12 Manual This is displayed if Louver button is pressed while function of automatic swing is unavailable. 13 Demand This is displayed when unit recieved demand instuction. Contents that can be operated with standard remote controller (YR-E02) and "CENTRAL"displays according to setting of central controller during central management with centralized controller (YR-E01). Setting of central controller Normal control "centralized" display of standard remote controller No display Contents that can be operated with remote controller Contents that can be operated with both standard remote controller and central controller, the latest setting works. Central control "central " Only ìon/offî and "TIMED ON/OFF" can be operated. Locked "central " flashes Operation disabled. Besides this standard circuit controller, ìTIMERî and ìcentral controllerî can also be used to practical control as seen from operation manuals attached with each remote controllers. 10