Haier AC24CS1ERA Operation Manual - Page 13

Installation Procedure Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. WARNING: Please call dealer to install the air-conditioner. Incorrect installation may cause water leaking, shock and fire hazard. CAUTION: Air-conditioner can't be installed in the environment with inflammable gases because the inflammable gases near air-conditioner may cause fire hazard. Installed electrical-leaking circuit breaker. It easily cause electrical shock without circuit breaker. Connect earthing wire. Earthing wire should not be connected to the gas pipe, water pipe, lightning rod or phone line, incorrect earthing may cause shock. SELECTING THE MOUNTING POSITION Decide the mounting position with the customer as follows: (1) Install the indoor unit level on a strong wall, floor, ceiling which is not subject to vibration. (2) The inlet and outlet ports should not be obstructed.The air should be able to blow all over the room. (3) Install the unit near an electric outlet or special branch circuit. (4) Do not install the unit where it will be exposed to direct sunlight. (5) Install the unit where connection to the outdoor unit is easy. (6) Install the unit where the drain pipe can be easily installed. (7) Take servicing etc. into consideration and leave the spaces shown in the figure below. Also install the unit where the filter can be removed. Use discharge pipe correctly to ensure efficient discharge. Incorrect pipe use may cause water leaking. Wiring Earthing Air-conditioner should be equipped with special power supply wire. Location Air-conditioner should be located in well-vented and easily accessible place. Air-conditioner should not be located in the following places: (1) Places with machine oils or other oil vapours. (2) Seaside with high salt content in the air. (3) Near hot spring with high content of sulfide gases. (4) Area with frequent fluctuation of voltage e.g. factory, etc. (5) In vehicles or ships. (6) Kitchen with heavy oil vapour or humidity. (7) Near the machine emitting electric-magnetic waves. (8) Places with acid, alkali vapour. Choose the following locations: (1) Capable of supporting air conditioner weight, don't increase operating noise and vibration. (2) Hot vapour from outdoor unit outlet and operating noise don't disturb neighbour. (3) No obstacles around the outdoor unit outlet. TV, radio, acoustic appliances etc. are at least 1 m far away from the indoor unit, outdoor unit, power supply wire, connecting wire, pipes, otherwise images may be disturbed or noises be created. As required, take measures against heavy snow. WARNING: Install at a place that can withstand the weight of the indoor and outdoor units and install positively so that the units will not topple or fall. CAUTION: (1)Do not install where there is the danger of combustible gas leakage. (2)Do not install near heat sources. (3)If children under 10 years old may approach the unit, take preventive measures so that they cannot reach the unit. Under ceiling Left Indoor unit Floor console Right may be difference 1.5m 30 cm or more Ceiling 1.5m Left Right 2 cm or more 30 cm or more 1.5m 30 cm or more Outdoor unit INSTALLATION PARTS The following installation parts are optional parts. Use them as required. Optional parts Adhesive tape Saddle (L.S) with screws Drain hose Piping hole cover Heat insulation material Putty Plastic clamp 11 Indoor unit