Haier AWO5100 User Manual - Page 18
Display Codes
View all Haier AWO5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 Display codes maintenance DISPLAY CODES AND SPECIAL FUNCTIONS CODES CAUSES SOLUTIONS Err1 ¬ Door is not properly shut. _ Shut the door properly. Err2 ¬ Drainage error, water not emptied within 4 _ Clean the filter and check the drain hose for blockage. If error minutes. still exists, please contact the maintenance personnel. Err3 ¬ Temperature sensor not properly connected or _ Contact the maintenance personnel. damaged. Err4 ¬ Heater error (Appears at the end of a cycle). _ Reduce load and then start washing again. If problem still exists, please contact the maintenance personnel. Err5 ¬Water level not met in 8 minutes. _ Make sure that tap is turned on, and water pressure is normal. If problem still exists, please contact the maintenance personnel. ¬The height of the drain hose is below 80 cm. ¬ The drain hose is in water. _ Install drain hose within 80-100 cm of height. _ Make sure the drain hose is not in water. Err7 ¬ Motor overheat protection or damage. Err8 ¬ Water exceeds protective level. End ¬ End of wash cycle. 1:25 ¬The remaining time is 1 hour 25 minutes. _ Contact the maintenance personnel. _ Contact the maintenance personnel. ¬ Control panel lock function: Press the "Delay" and the "Temperature" buttons simultaneously for 3 seconds after starting a program. It can no longer be changed by operating buttons or knobs. To unlock press the "Delay" and "Start/Pause" buttons again for 3 seconds. ¬ Power-off memory function: In case of abrupt power failure or the need to cut off the power during a program cycle, the present settings will be saved and the preset operation will resume when the power is on again. ¬ To cancel a program Press the "Start/Pause" button, then switch off the power and the program is automatically cancelled. Turn the program selector again to choose another program.