Haier BCF27 User Manual - Page 6
Electrical Requirement, Installation Limitations, Use of Extension Cords, Door Alignment
View all Haier BCF27 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
English WARNING: ELECTRICAL REQUIREMENT - SHOCK HAZARD Electrical Requirement • Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper grounding to power the refrigerator. • Avoid the use of three prong adapters or cutting off the third grounding prong in order to accommodate a two prong outlet. This is a dangerous practice since it provides no effective grounding for the refrigerator and may result in shock hazard. WARNING: USE OF EXTENSION CORDS- POTENTIAL SAFETY HAZARD Use of Extension Cords • Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance. DO NOT USE EXTENSION CORD LONGER THAN 12 FT. Installation Limitations • Do not install your refrigerator in any location not properly insulated or heated, e.g. garage, etc. Your refrigerator was not designed to operate in temperature settings below 55˚ Fahrenheit. • Select a suitable location for the refrigerator on a hard even surface away from direct sunlight or heat source, e.g. radiators, baseboard heaters, cooking appliances, etc. Any floor unevenness should be corrected with the leveling legs located on the front bottom corners of the refrigerator. Door Alignment (see fig. # 1) 1. Remove the top hinge cover by using a flathead screwdriver. Place the head under the front edge of the cap and gently lift. 2. Loosen the top hinge screws using a Phillips head screw driver. 3. Adjust the door or put a spacer in between and tighten the screws. 4. Replace the top hinge cover by aligning the rear of the cover with the rear of the hinge. Press firmly on the front of the cover until it snaps in place. 5 fig. 1