Haier CJ35M Use and Care Guide - Page 7

2. Pour the water through the opening into a sink or tub. 0 fi 3. Reinstall the bucket. IMPORTANT: If the Bucket Full indicator light comes on, the dehumidifier will not operate. Empty or adjust the bucket. Option 2-Comect Drain Hose If you plan to run your dehumidifier continuously, and have a drain close by, you may want to attach the drain hose (provided) to the drain hose connector on the back of the dehumidifier. 1. Remove the drain hose from the dehumidifier bucket. A. Drain port C. Drain cap B. Rubber seal ring inside drain hose D. Drain hose 5. Insert the drain hose into the drain port. Turn the drain cap clockwise to tighten. 0 0 • A. Drain hose (3 ft [91.4 cm] length) 2. Remove the drain cap and rubber drain plug. Store the rubber drain plug in the dehumidifier bucket for later use. 0 0 6. Place the other end of drain hose into a floor drain. Check that the drain hose lies flat and is in the drain. Option 3-Connect Drain Tube to Drain Pump (Models CJ70EP Only) If you plan to run your dehumidifier continuously, and you need a longer drain hose or the drain location is above the dehumidifier, you may want to attach the 16 ft (4.9 m) long drain tube (provided) to the drain pump connector on the back of the dehumidifier. When the water level inside the bucket reaches the correct level, the drain pump automatically pumps the water to the drain. 1. Remove the drain hose and drain tube from the dehumidifier bucket. A. Drain port B. Rubber drain plug C. Drain cap 3. Insert the drain hose through the hole in the drain cap. 4. Check that the rubber seal ring is seated correctly in the end of the drain hose. B • , ).100P' A. Drain hose (3 ft [91.4 cm] length) B. Drain tube (16 ft [4.9 m] length) 7