Haier DM32EK DM32EK Manual - Page 6

Proper

Page 6 highlights

PROPER USE & CARE It is normal for the surrounding air to become slightly warmer as the dehumidifier operates. This warming effect further reduces the relative humidity of the surrounding air. THERE ARE TWO WAYS TO REMOVE WATER FROM THE BUCKET: 1. Empty the bucket manually When the water bucket is full, the red indicator light "BUCKET FULL" will go on. 1. YOU MUST turn the POWER off. 2. Wait a few minutes to allow the water to stop dripping. 3. Use both side handles to lift and remove the bucket. 4. Empty water through opening into a sink or tub. 5. Reinstall bucket. IMPORTANT Make sure the drain cap is tightened before operating the unit. 2. Attach a standard garden hose The direct drainage feature can be activated using the following steps. 1. Remove the plastic cap at the rear of the unit. (Keep the rubber insert well for use later.)(Fig.#1) 2. Tightly screw the purchased garden hose to the direct drain opening.(Fig. #2) 3. Position the dehumidifier as close as you can to the floor drain. 4. Position the opening end of the drain hose directly over the floor drain and start the unit. 5. When the direct drain feature is not being used, remove the drain hose from the direct drain opening and plug it with the rubber cap provided. 6 a a WI Fig.#1 a a Fig. #2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

PROPER
USE
&
CARE
It
is
normal
for
the
surrounding
air
to
become
slightly
warmer
as
the
dehumidifier
operates.
This
warming
effect
further
reduces
the
relative
humidity
of
the
surrounding
air.
THERE
ARE
TWO
WAYS
TO
REMOVE
WATER
FROM
THE
BUCKET:
1.
Empty
the
bucket
manually
When
the
water
bucket
is
full,
the
red
indicator
light
"BUCKET
FULL"
will
go
on.
1.
YOU
MUST
turn
the
POWER
off.
2.
Wait
a
few
minutes
to
allow
the
water
to
stop
dripping.
3.
Use
both
side
handles
to
lift
and
remove
the
bucket.
4.
Empty
water
through
opening
into
a
sink
or
tub.
5.
Reinstall
bucket.
IMPORTANT
Make
sure
the
drain
cap
is
tightened
before
operating
the
unit.
2.
Attach
a
standard
garden
hose
The
direct
drainage
feature
can
be
activated
using
the
fol
lowing
steps.
WI
1
.
Remove
the
plastic
cap
at
the
rear
of
the
unit.
(Keep
the
rubber
insert
wel
l
for
use
later.)(Fig.#1)
2.
Tightly
screw
the
purchased
garden
hose
to
the
direct
drain
opening.(Fig.
#2)
3.
Position
the
dehumidifier
as
close
as
you
can
to
the
floor
drain.
4.
Position
the
opening
end
of
the
drain
hose
directly
over
the
floor
drain
and
start
the
unit.
5.
When
the
direct
drain
feature
is
not
being
used,
remove
the
drain
hose
from
the
direct
drain
opening
and
plug
it
with
the
rubber
cap
provided.
6
a
a
a
a
Fig.#1
Fig.
#2