Haier DW12-AFM4 User Manual - Page 7
Turning, on the Appliance, Wash Cycle Adjustment Buttons
![]() |
View all Haier DW12-AFM4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Turning on the Appliance Starting a wash cycle - Make sure that the plug for the appliance is inserted into the wall socket. - Make sure that the water supply is turned on to full pressure. - Load the dishwasher (see the section entitled, "Loading the Dishwasher" on page 5). - Pour in the detergent (see the section entitled, "Salt, Detergent and Rinse Aid" on page 3 and 4). - Turn the knob located on the right of the control panel in clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table" on page 8). - Press the ON-OFF button, and the ON-OFF light will turn on. At this point, the wash cycle will begin. If you forget to load some of the dishes The wash cycle can be interrupted by pressing the ON-OFF button. You can then load additional dishes and turn the appliance back on. The cycle will start where it left off. At the end of the wash cycle When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher. Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. Cancelling or modifying a wash cycle setting A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent may have already been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent" on page 4). Press the ON-OFF button, and the ON light will turn off. Rotate the knob in clockwise direction to the desired cycle setting (see the section entitled: Starting a wash cycle ?F. Then, turn the dishwasher back on using the ON-OFF button. Wash Cycle Adjustment Buttons Button This button (see "close-up View - Control Panel" on page 1, letter "G" ) is used for normal dirty dishes, pots and pans. It is a standard daily cycle. It can be used before setting any of the wash cycles, except for the intensive cycles (if included in the wash cycle table ). Please keep in mind that the amount of detergent should also be cut in half. 1/2 load Button This button (see "close-up View - Control Panel" on page 1, letter "H" ) makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and electricity. Pots and Pans Button When intensive wash mode, normal wash mode or rinse mode is set, press the button (see "Close-up View - Control Panel ", letter "I") to increase the water temperature for heavily stained pots and pans. .6. GB
![](/manual_guide/products/haier-dw12afm4me-user-manual-1328383/7.png)