Haier DW12-BFESS User Manual - Page 7
Turning, on the Appliance
View all Haier DW12-BFESS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Turning on the Appliance Starting a wash cycle Setting the Wash Cycle with a Delayed Start Time After having completed all of the installation steps in the preceding paragraphs, turn on the water all the way and press the ON- Premise: After selecting the wash cycle as indicated in the paraOFF button (A) located on the control panel. The "B" indicator graph entitled, "Setting and Starting a Wash Cycle..." the delay light will come on. At this point, the appliance is on but you must time can be set. wait a few seconds before programming the setting for the cycle. Setting and Starting a wash Cycle Select the desired cycle by pressing the selector button (G). Each By pressing the "E" button (see close-up view-'Control panel") time the button is pressed, one of the "H" cycle indicator lights will the start of wash cycle can be delayed for between 1 to 9 hours. come on in succession. Choose the wash cycle you feel is most Each time the button is pressed, the display (F) will show the appropriate for the type of dishes that need washing (consult the number of hours for the delay period. Choose the amount of wash cycle table contained in this manual, especially when first time desired. When the appliance is started with "I" button, a short using the appliance). acoustic signal will sound and the delay time on the display will Press the Start/Pause button (I), and after a few seconds a short blink, indicating that the countdown has begun. acoustic sound will indicate that the wash cycle has begun and can no longer be changed. If necessary, read the paragraph en- titled" Cancelling or modifying a cycle while underway..." After the time has lapsed, the cycle will start. Cancelling or modifying a cycle while underway Premise : A cycle that is underway can only be modified if it has NOTE: only been running for a short time. Otherwise, the detergent may have already been used, and the appliance mayhave already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent"). To modify a cycle that is already underway, press the ON-OFF button (A), then all of the settings will be cancelled. a) During the delay period, it is preferable not to change any of the settings. If it is necessary, all of the settings must be cancelled by pressing the ON-OFF button (A) to indicate that all of the settings have been cancelled. At this point, all of the steps for "Setting the Wash Cycle with a delayed Start Time" and "setting and Starting a Wash Cycle" must be repeated, following the instructions contained in the correspond- ing sections. If you forget to load some of the dishes b) If the door is opened during the delay period, the indicator will blink and acoustic signal will sound, and the countdown will stop. The wash cycle can be interrupted by pressing the Start/Pause It will begin again when the door is closed . button. You can then load additional dishes and turn the appli- ance back on. The cycle will start where it left off. Wash cycle Programme Light Wash Cycle adjustment Buttons The wash cycle is running and the cycle indicator light (H) for the cycle will begin to blink. 1/2 load Button This button (see "close-up View - Control Panel", letter "C") make At the end of the wash cycle it possible to wash dishes using only the upper rack if there are Six acoustic signal will indicate that the wash cycle has finished not enough dishes for a full load. This will allow you to save on and the cycle indicator light (H) for the cycle will begin to die out. water and eletrical energy. It can be used before setting any of Turn off the appliance using the ON-OFF button. Turn off the the wash cycles, except for the intensive cycle (if included in the water supply to the appliance and open the door. Wait a few wash cycle table). Please keep in mind that the amount of deter- minutes before unloading the dishwasher to avoid handling the gent should also be cut in half. dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better. GB .6.