Haier DW9-LBE User Manual - Page 10
Cleaning and Special Maintenance, Troubleshooting
View all Haier DW9-LBE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is advisable to remove the larger food particles trapped in the filter after each wash cycle by rinsing the semi-circular filter and cup (A) under running water. To remove the filter assembly, pull on the cup handle in the upward direction. The entire filter assembly (made up of the semicircular filter (A) and fine filter (B)) should be cleaned at least once a month. To clean the filter and fine filter, use a cleaning brush. Then, reassemble the filter parts as shown in the figures below and refit the entire assembly in the dishwasher, positioning it in its seat and pressing downward. The dishwasher must never be used without the filters. Improper replacement of the filters may reduce the performance of the appliance and damage dishes and utensils. Cleaning the Spray Arms It may happen that food particles become encrusted on the sprayer arms and block the holes (see "Close up view interior", letters C-E ). Check the sprayer arms periodically and clean them when needed. Cleaning the Water Inlet Filter Periodically clean the water inlet filter located on the outlet of the water supply tap. After turning off the water tap, unscrew the end of the water A supply hose, remove the filter and clean it carefully under run- ning water. Then, return the filter to its place and tighten the water supply hose back into position. B Troubleshooting It may occur that the dishwasher does not function or does not The dishwasher does not drain have you checked whether: function properly. Before calling for assistance, See what can - the drain hose is crimped or bend. be done first: have you forgotten to press one of the buttons or to perform an essential operation? Lime Deposits or a White Film Form on the Dishes Have you checked whether: The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the lid to the salt container is closed properly; - the rinse aid dosage is correct. If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised service centre and provide them with the following information: - the nature of the problem; - the model type number (Mod...) and the serial number (S/N...), which are indicated on the plate located on the side of the inner The Dishwasher Does Not Load Water part of the door. Have you checked whether: Never call on unauthorised technicians and refuse to al- - the water is turned on and the hose is connected properly; low parts to be installed that are not original spare parts. - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bend; - the filter for the water supply hose is clogged. .9. GB