Haier ES100V-G1 User Manual - Page 1

Troubleshooting Symptom Things to Check Solutions 1aWhether the water supply has stopped or whether the water pressure is too Check low 2aWhether the water-usage point is blocked or whether the hot water Check and clear valve is openeded 1aWhether hot water outlet is opened Check and open Only cold 2aWhether the water water but the temperature is adjusted heating indicator lamp is lit 3aHeating time is too short and set temperature is not achieved 4aWhetehr heating pipe is damaged Only cold water and 1aWhether power is properly connected the heating indicator lamp is not lit 2aWhether thermostat out of control is Increase the temperature to the required value. Once the water is heated to the pre-set temperature, control flow volume of cold and hot water using the moderating mixing valve. Adjust water temperature Confirm it is not due to the reasons under æ,ç and è, then contact Maintenance Department Check power socket Confirm that this is not due to reason æ, then contact Maintenance Departmentnt Heating 1aWater has not reached indicator the set temperature light Is on all 2aWhether thermostat is the time out of control Water volume is sometimes large or small, Whether water pressure is or water is stable sometimes hot or cold 1aWhether the present Samll hot temperature setting is water outflow too low volume 2aWhether water pressure is too much Continue heating Confirm that this is not due to reason æ, then contact Maintenance Departmentnt Set lower mixing valve or ensure water pressure is stable before use Calibrate using the method stipulated in the Instruction Manual Set lower mixing valve 0040503115 004V05**0*2**335 V Haier Home Water Heater Instruction manual ES50V-G1(H) ES70V-G1(H) ES100V-G1(H) Please read this Instruction Manual carefully before use. Please retain this manual for future reference. Safety Notices(Please read before use) Meanings of Icons These are actions which are forbidden Forbidden These are actions which must be carried out Warning These are matters for which attention is required CAUTION Immediately cut off power supply and contact our Service Center once the water heater does not work properly or emits burnt smell. Storing of inflammable and explosive items near the water heater is strictly prohibited. Forbidden This icon is used by Haier Water Heaters to indicate " safety warning experts". It indicates that the product is Do not connect to power when installing or repairing the water heater. equipped with special t Forbidden echnology that constantly monitors the status of your earth line, to ensure safety during showering.If the icon is lit, it means that there is electricity in the earth line. You should immediately Non-professionals are strictly prohibited from carrying out repairs, maintenance, dismantling Forbidden or revamping of the water heater. stop using the water heater and disconnect the power plug. Do not touch the outer casing of any electrical appliances in your home. Remember to also contact the local After-sales department or property Forbidden Installation of water heater outdoors is strictly prohibited. management company in order for them to engage qualified electricians to carry out a system check until the icon is no longer lit. Do not install the water heater in an environment which is susceptible to ice-formation. Ice will cause the container and water pipe to break, 220V/50Hz independent power source Forbidden leading to scalding and water leakage. must be used at all times. Warning To ensure safety, the water heater should be connected to independent sockets (do not use adapters), with reliable earthing. Please take precautionary measures during cold weather, in order to prevent damage to water Warning heater from freezing. In addition, the power socket must conform Earthing to national standards. Use of water heater without reliable earthing is strictly prohibited. Use pen multimeter to check whether the live line and zero line are reverse. Warning If the soft power cable is damaged, it must be replaced by professional staff from the manufacturers or Maintenance Department in order to avoid danger. Do not use damaged wire and power socket. Promptly clean the dust on the Take care not to be scalded by heated water. power plug and socket. Warning · Touching of hot water valve and pipes is strictly prohibited. Check the power meter and the electric wire's diameter to ensure that they comply CAUTION · Make sure to check the water temperature use; use only when it feels suitable. before with the rated current for the water heater. Warning Where necessary engage qualified electrician to check the electric circuit. Do not use water from the water heater for drinking or similar purposes. Forbidden Forbidden Do not touch the plug with wet hands, and make sure that the water heater, plug socket do not come into contact with water. If they are accidentally wet, they must be checked by professions appointed by our CAUTION company before using, in order to prevent Please cut off the power supply if the water heater was not used for an extended period of time. Drain the water heater of all water according to the instructions in the chapter on Cleaning and Maintenance. electrocution. Electrical Diagram·Exterior and accessories· Technical parameters Electrical Diagram L:Live wire (brown) N:Neutral line (blue) MT:Manual-reset thermostat BT:Adjustable thermostat HL:Heating indicator light EH:Heating tube E:Earth line (yellow-green; dual color) MT BT L N E EH HL E Exterior and accessories Front view Rear view Side view Cross-section view F AB A : Hot water outlet B : Cold water inlet C : Inner chamber D : Temperature measurement pipe E : Heating pipe F : Magnesium rod G : Wall hook Model No. Capacity (L) Net weight (kg) a1 (mm) b1 (mm) c1 (mm) d1 (mm) e1 (mm) f1 (mm) ES50V-G1(H) 50 1199.5.5 410 420 730 100 200 320 ES70V-G1(H) 70 23.5 410 420 935 100 200 480 ES100V-G1(H) 110000 30 347100 348200 1230 110000 220000 730 Note͇1.The margin of error for the above parameters (measurements, weight) is ±10%. 2.The thermometer is not a precision instrument. It consists of three areas denoted by blue; orange and red, which indicate the temperature of water in the inner chamber from low to high respectively. Technical parameters Voltage Rated power Rated pressure Waterproof rating Water pressure 230V~,50Hz 2150W 0.80MPa IPX4 Not less than 0.05MPa 1 2