Haier ESRB03W User Manual - Page 6

English installing your refrigerator Unpacking Your Refrigerator 1. Remove  all packaging material. This includes the foam base and all adhesive tape holding the accessories inside and outside. 2. I nspect and remove any remains of packing, tape or printed materials before powering on. Proper Air Circulation •T  o assure your refrigerator works at maximum efficiency, you should install it in a location where there is proper air circulation, plumbing and electrical connections The following are recommended clearances around the refrigerator:  Sides...3/4" (19mm) Top...2" (50mm) Back...2" (50mm) Electrical Requirement •M  ake sure there is a suitable power outlet (115 volts, 15 amps outlet) with proper grounding to power the unit. •A  void the use of three plug adapters or cutting off the third grounding in order to accommodate a two plug outlet. This is a dangerous practice since it provides no effective grounding for the unit and may result in shock hazard. Use of Extension Cord •A  void the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance. Installion Limitations •D  o not install in any location that is not properly insulated or heated (e.g. garage etc.). Your unit was not designed to operate in temperature settings below 55˚ Fahrenheit. •S  elect a suitable location on a hard, even surface away from direct sunlight or heat source (e.g. radiators, baseboard heaters, cooking appliances etc.). Any floor unevenness should be corrected. 5