Haier HDW300SS User Manual - Page 9

Troubleshooting If the dishwasher does not function or does not function properly. Before calling for assistance, check to see what can be done first: have you forgotten to press one of the buttons or to perform an essential operation? The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the ON-OFF switch is on "ON"; - the water supply is turned on. The Dishwasher Does Not Fill With Water Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house is on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter in the water supply hose is clogged. The Dishes Are Not Clean Have you checked whether: - Dishwasher was loaded properly. Jets of water could not reach all parts of the dishes, etc; - Too many items in the rack; - Items in the rack were touching each other; - Not enough detergent was added to dispenser; - Selected wash programme was intensive enough; - Rotation of spray arm was obstructed by dish, etc; - Nozzles in spray arm are blocked by remnants of food; - Coarse or fine filter or microfiller is blocked; - Filters have been incorrectly fitted; - Drain pump is jammed; Error Messages The dishwasher is equipped with a safety system that is able to detect operating problems and malfunctions. These malfunctions are signalled by the rapid blinking of one of the "M" program LEDs. Only in the case where the indicator light for the soak cycle (see table for cycles) blinks rapidly should you cancel the cycle as described in the section entitled, "Changing a Cycle while Underway." Then check to make sure that there is water in the mains and that the tap is turned on. If the problem continues, call for technical assistance, indicating which light was flashing. If any of the other indicator lights begin to blink rapidly, turn off the appliance and call for technical assistance, advising which lights were flashing. If, despite all these checks, the dishwasher still does not function and/or the problem persists, contact the nearest authorised service centre and provide them with the following information: - the nature of the problem; - the model number AND serial number, which are on the plate located on the side of the inner part of the door. Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts. The Dishwasher Does Not Drain Have you checked whether: - the drain hose is crimped or bent. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the rinse aid dosage is correct. .8. GB