Haier HNSE045 HNSE045 Manual - Page 9
Door Alignment
View all Haier HNSE045 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
English NOTE: A s the door gets pressed in during shipping, after reversing the door, the gasket may have to be reset. This is done to prevent the cool refrigerated air from escaping. If there is a gap between the door gasket and the cabinet, set the gasket by gently pulling it out to seal the gap. Door Alignment 1. Remove the top hinge cover. 2. Loosen the top hinge screws using a phillips head screwdriver. 3. Adjust the door or put a spacer in between and then tighten the screws. 4. Replace the top hinge cover. 8
8
English
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a phillips head screwdriver.
3. Adjust the door or put a spacer in between and then tighten the
screws.
4. Replace the top hinge cover.
Door Alignment
NOTE:
As the door gets pressed in during shipping, after reversing
the door, the gasket may have to be reset. This is done to
prevent the cool refrigerated air from escaping. If there is a
gap between the door gasket and the cabinet, set the gasket by
gently pulling it out to seal the gap.