Haier HPE20SS Product Manual - Page 8

English How to Prepare Espresso Coffee Hints and Tips • Preheating the machine will ensure that your coffee is dispensed at the correct temperature. • It is important to use a high quality ground coffee with a fine grind in order to avoid obstruction of the filter during brewing. • Always make sure the filter is clean before filling with coffee grinds. • Espresso is a strong dark coffee with a distinctive caramel colored froth known as the "crema". Tamping the grinds will give a better quality espresso. If the grind is not pressed enough, it will come out too quickly and the crema will be light in color. • Espresso coffee is best served in small demitasse cups, with a halfcup being the ideal serving size (approx. 1-1/2 to 2 fl. oz.). 1. Preheat the espresso cups by placing them on top of the machine under the clear upper cover. 2. After preheating of the machine as described in the preceding sec- tion, insert either the 1 or 2-cup filter depending on the number of cups of espresso being made. Make sure that the filter is clean and dry. To make just one cup of espresso, insert the 1-cup filter into the filter holder and fill it with one level measuring spoon of ground cof- fee - about 0.25 oz. To make two cups of espresso, insert the 2-cup filter into the filter holder and fill with two level measuring spoons of ground coffee - about 0.50 oz. 3. Remove any excess coffee grind from the filter holder rim. Tamp down the grinds in a slight twisting motion with the tamping tool (the flat end of the measuring spoon) and attach the filter holder to the machine by positioning it under the boiler outlet with the arrow on the handle pointing towards the left arrow (open) on the housing. Push upwards and turn the handle to the right so that it points to the triangle marking at the center of the housing (close). Note: To use a single-serve coffee pod, place the pod into the 1-cup filter and attach the filter holder to the machine. 4. Place the cup or cups on the removable drip tray. Ensure that the cup or cups line up with the dispensing holes on the filter holder. 5. Wait until the green "OK" light comes on, then turn the switch to the espresso function until the desired amount of espresso has been brewed (approx. 1-1/2 to 2 fl. oz. or 1/2 "demitasse" cup). Then turn the switch back to the original position. 6. Once the machine has stopped dispensing the espresso, turn the handle of the filter holder from the right to left to detach it. 7. To remove the used coffee grinds, lock the filter in place with the protective thumb guard that is built into the handle and knock the coffee grounds out of the overturned filter holder. Wipe any leftover grounds from the filter with a towel. 8. After removing the filter holder, place a cup on the removable drip tray and press the button for a couple seconds to clean out the 7 system. 9. To brew more espresso, repeat all the steps above. Otherwise, turn off the espresso machine.