Haier HRD-211 User Manual - Page 8

SETTING UP UNPACK THE REFRIGERATOR Unpack your refrigerator in the presence of company personnel and check for transit damage before installing the refrigerator. In case of damage, inform your dealer immediately and don't install the unit. SELECT A WELL -VENTILATED LOCATION Choose the location of your refrigerator away from all direct heat sources. Allow sufficient clearance (at least 10 cm) on the sides, rear and top of the refrigerator, for effective dissipation of heat from the condenser. CHECK REFRIGERATOR LEVELING When properly leveled, the refrigerator door should shut gently when released from an angle of less than 45°. To adjust leveling, rotate the adjustable screws below the refrigerator on all four sides. IDENTIFY THE NEAREST ELECTRICAL OUTLET Your refrigerator should preferably be close to an electrical outlet so that the wire does not lie on the floor. Connect the refrigerator to a single phase 230 V, 50 Hz AC supply, that has been properly earthed. (Call an electrician to check, or install one if necessary.) If you have a separately fused circuit, use a fuse rated at 15 amps. CLEAN THE REFRIGERA' Use a soft, damp cloth with a mild detergent to clean the refrigerator thoroughly from the inside and the outside. Leave the doors open for a while to let it dry completely. LET THE REFRIGERATOR STAND FOR 24 HOURS Your Refrigerator could have been tilted during transport / handling. To allow all intemal mechanisms to get back to normal, keep the refrigerator standing for at least 24 hours before switching it ON. RUN THE REFRIGERATOR FOR 2-3 HOURS Allow the refrigerator to cool sufficiently, before loading food, by running it with the temperature control knob at MAX setting.