Haier HRT02WNC User Manual - Page 7
Use of Extension Cord, Install Limitations, Door Alignment
UPC - 688057303963
View all Haier HRT02WNC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
English Use of Extension Cord • Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance. Install Limitations • Do not install your refrigerated cooler in any location not properly insulated or heated e.g. garage etc. Your refrigerated cooler was not designed to operate in temperature settings below 55˚ Fahrenheit. • Select a suitable location for the refrigerated cooler on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc. • Your refrigerated cooler was designes to operate at appropximately 20º - 25º below room (ambient) temperature when set at maximum settings. Door Alignment (see fig. #1) 1. Remove the top hinge cover by using a flathead screwdriver. Place the head under the front edge of the cap and gently lift. 2. Loosen the top hinge screws using a Phillips head screw driver. 3. Adjust the door or put a spacer in between and tighten the screws. 4. Replace the top hinge cover by aligning the rear of the cover with the rear of the hinge. Press firmly on the front of the cover until it snaps in place. fig. 1 6