Haier HSU-09CA03 User Manual - Page 12

Operation TIMER operation Set Clock correctly before starting Timer operation(refer to page 4) You can let unit start or stop automatically at following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER ON/OFF (1)After unit start, select your desired operation mode. Operation mode will be displayed on LCD. Power indicator on indoor unit lights up. (2)TIMER mode selection Press TIMER button to change TIMER mode. Every time the button is pressed, display changes as follows: • ON OFF ON 0 OFF -N. blank 1 TIMER ON TIMER OFF TIMER ON-OFF Select your desired TIMER mode (TIMER ON or TIMER OFF) ON or OFF will flash. (3)Timer setting Press HOURA/ V button. A Every time the button is pressed, time increases 10 min. If button is kept depressed, time will change quickly. V Every time the button is pressed, time decreases 10 min. If button is kept depressed, time will change quickly. Time will be shown on LCD. It can be adjusted within 24 hours. (4)Confirming your setting After setting correct time, press SET button to confirm "ON" or "OFF" stops flashing Time displayed: Unit starts or stops at x hour x min (TIMER ON or TIMER OFF). Timer mode indicator on indoor unit lights up. To cancel TIMER mode go -I r n1o1C AM /200 LEI AM /200 ( A )TEMP( ) ON O SWING OF 1 (MODE) CLOCK MERI (SLEEP) I SE OCK RESET O O El=l• Just press TIMER button several times until TIMER mode disappears. Hints After replacing batteries or a power failure happens, Time setting should be reset. Remote controller possesses memory function, when use TIMER mode next time, just press SET button after mode selecting if timer setting is the same as previous one. 10