Haier HSU-12RS03 User Manual - Page 3
Operation
View all Haier HSU-12RS03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Operation Inner side of the controller 2 Load the batteries as illustrated. 2 R-03 SMART COOL SET TEMP. ROOM TEMP. HEAT FAN operating power is 100W; when the panel display "02", the operating power is 200W, and so forth) 21.LIGHT button 3 batteries,resetting key(cylinder); Be sure that the loading is in line with the " + "/"-"; DRY CTD AUTO FAN POWER SPEED SOFT AUTO AUTO Control the lightening and extinguishing of the indoor LED display board. Load the battery,then put on the cover again. ECO iFP TIMER ON OFF AM the manual of how to display set tempğ PM 26 Press LIGHT button continuously 27 for ten times, the display temp on Clock set SMART 25 24 display panel can be changed from ambient temp to set temp. 28 Set temp function only valuable 29 for RS. 1 Press CLOCK button, 23 30 22.POWER / SOFT button 23.10ć 22 31 special heating set function: "AM" or "PM" flashes. 2 Press "+" or "-" to set 21 10 degree heating maintaining 32 20 (valuable for RS) correct time. 19 33 24.HEALTH AIRFLOW AM button PM 18 34 25.HEALTH button 18.CODE button Used to select CODE A or B with a press, A or B will be displayed on LCD.Please select A without special explanation. 19.RESET button When the remote controller appears abnormal,use a sharp pointed article to press this button to reset the controller normal. 20.INQUIRE button Inquire the external environmental temperature and the operating power of the machine. (e.g. when the panel display "01", the 26.SWING UP/DOWN button 27.SWING LEFT/RIGHT button 28.FRESH button 29.SLEEP button 30.TIMER ON / OFF button 31.HOUR button 32.CANCEL/CONFIRM button Used to confirm timer and clock settings. 33.CLOCK button 34.LOCK button If pressed, the other buttons will be disabled. Press it once again,lock will be cancelled. This function unavailable on this models. Loading of the battery SMART Each press will increase or decrease 1min.If the button is kept pressed,time will change quickly. 3 Confirm time. After time setting is confirmed, press CONFIRM,"AM "and "PM" stop flashing,while clock starts working. Note: The distance between the signal transmission head and the receiver hole should be within 7m without any obstacle as well. When electronic-started type fluorescent lamp or change-over wireless telephone is installed in the type fluorescent lamp or room, the receiver is apt to be disturbed in receivingthe signals, so the distance to the indoor unit should be shorter. Full display or unclear display during operation indicates the batteries have been used up.Please change batteries. If the remote controller can't run normally during operation, please remove the batteries and reload several minutes later. 1 Remove the battery cover; Hint: Remove the batteries in case unit won't be in usage for a long period.If there are any display after taking-out,just need to press reset key. 3