Haier HSU-24HEK03 User Manual - Page 4

Operation HEALTH Operation (This function is unavailable on some models.) HEALTH ON/OFF FAN The anion generator in the airconditioner can generate a lot of anion effectively balance the quantity of position and anion in the air and also to kill bacteria and speed up the dust sediment in the room and finally clean the air in the room. TIMER CLOCK SET SLEEP LOCK RESET (3) TIMER ON-OFF TIMER CLOCK SET SLEEP LOCK RESET TIMER CLOCK SET SLEEP LOCK RESET TIMER CLOCK SET SLEEP LOCK RESET TIMER CLOCK SET SLEEP LOCK RESET Healthy Negative ions TIMER Operation Set Clock correctly before starting Timer operation You can let unit start or stop automatically a following times: Before you wake up in the morning, or get back from outside or after you fall asleep at night. TIMER CLOCK SET SLEEP LOCK RESET (1) TIMER ON TIMER CLOCK SET SLEEP LOCK RESET (2) TIMER OFF TIMER CLOCK SET SLEEP LOCK RESET TIMER CLOCK SET SLEEP LOCK RESET TIMER CLOCK SET SLEEP LOCK RESET 3 To cancel TIMER mode Just press TIMER button several times untilTIMER mode disappears. Emergency operation and test operation Emergency Operation: Pi Use this operation only when the remote controller is defective or lost. When the emergency operation switch is pressed,the" Pi "sound is heard once, which means the start of this operation. In this operation, the system automatically selects the operation modes,cooling or fan or heat,according to the room temperature. Room Operation Designated Timer temperature mode temperature mode Air flow ABOVE 23OC COOLING 26OC NO AUTOMATIC BELOW 23OC HEAT 23OC NO AUTOMATIC (Cooling only uint） Room temperature Operation Designated mode temperature BELOW 23OC FAN 26OC It is not possible to operate in dry mode. Timer mode NO Air flow AUTOMATIC Test operation: Test operation switch is the same as emergency switch. Use this switch in the test operation when the room temperature is below 16oC, do not use it in the normal operation. Pi Pi Continue to press the test operation switch for more than 5 seconds. After you hear the "Pi" sound twice,release your finger from the switch: the cooling operation starts with the air flow speed "Hi".