Haier HUF138EA HUF205EA Manual - Page 12

English Reversing the Door (fig. 5 & 6) This freezer is equipped with a reversible door for left/right opening. If you prefer to change the direction of door opening, follow the steps below: Note: The freezer comes with the door hinged to the right. Installing the Door Shim Door Pin washer fig. 5 fig. 6 1. Fix the freezer door in place with strong adhesive tape. 2. Dismantle the hinge box cover on the top of the freezer door with a Phillips screwdriver and remove the 2 screws from the hinge. Take out the hinge by pulling up vertically. Put these aside. (see fig. 5) 3. Remove the adhesive tape on the freezer door, lift and take the door down.Carefully put it aside. 4. Remove the door pin from the bracket of the lower hinge by turning it counter clockwise. Move the pin to the opposite hole and tighten. (see fig. 6) 5. Remove the 4 screws from the lower hinge with a Phillips screwdriver. Remove the washer and shim from the right side and install them to the left side. 6. Align the holes in the lower hinge bracket to the corresponding holes on the opposite side of the cabinet. Insert and tighten screws. 7. Align the bottom hole on the lower left side of the door with the pin of the lower hinge and slide into place. 8. Align the pin of the top hinge with the top hole on the left side of the door and push in place. Replace the screws in the upper hinge bracket but do not tighten all the way. 9. Align the door from top to bottom and tighten the 2 screws on the top hinge. 10. Snap on the hinge box cover. 11. On some models you need to screw the hinge box cover using a phillips screw driver. 10