Haier HVFM20ABB User Manual - Page 6

EEnngglliisshh Installing Your Wine Cooler Unpacking Your Wine Cooler 1. Remove all packaging material. This includes the foam base and all adhesive tape holding the wine cooler accessories inside and outside. Slide out and remove plastic or foam guard used to secure the compressor from shipping damage due to vibration and shock. 2. Inspect and remove any remains of packing, tape or printed materials before powering on the wine cooler. Leveling Your Wine Cooler • Your wine cooler has four leveling legs which are located in the front and rear corners of your wine cooler. After properly placing your wine cooler in its final position, you can level your wine cooler. • Leveling legs can be adjusted by turning them clockwise to raise your wine cooler or by turning them counterclockwise to lower your wine cooler. The wine cooler door will close easier when the leveling legs are extended. Proper Air Circulation • To assure your wine cooler works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation, plumbing and electrical connections. • The following are recommended clearances around the wine cooler: Sides 2 "(50mm) Top 2" (50mm) Back 2" (50mm) • Do not over fill your wine cooler for proper internal air circulation. 55