Haier HVTSM18DABB HVTSM18DABB Manual - Page 6
Grounding Instructions, Use of Extension Cords, Installation Limitations, Door Alignment
UPC - 688057382203
View all Haier HVTSM18DABB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
English Grounding Instructions • Make sure there is a suitable power outlet (115V~60Hz 15A) with proper grounding to power the wine cellar. • Avoid the use of three plug adapters or cutting off the third grounding pin in order to accommodate a two plug outlet. This is a dangerous practice since it provides no effective grounding for the wine cellar and may result in shock hazard. Use of Extension Cords • Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or greater than the electrical rating of the appliance. Installation Limitations • Do not install your wine cellar in any location not properly insulated or heated e.g. garage etc. • Select a suitable location for the wine cellar on a hard even surface away from direct sunlight or heat source e.g. radiators, baseboard heaters, cooking appliances etc. Any surface unevenness should be corrected with the leveling legs located on the front and rear bottom corners of the wine cellar. Avoid placing unit where there may be electrical interference. • Your wine cellar is designed for free-standing installation only. It is not designed for built-in application. NOTE: To minimize the risk of rusting, leakage and insulation damage, avoid placing the unit in a place where heavy moisture is present. Under no circumstances spill or directly apply water onto or into the unit. Door Alignment 1. Remove the top hinge cover using a flat head screwdriver. 2. Gently move wires aside and loosen the 3 screws using a Phillips Head Screwdriver. 3. Adjust the door and tighten the screws. 4. Replace the top hinge cover. 5. Adjust bottom hinge if necessary. 5