Haier HWM110-0566 User Manual - Page 8
Install the water inlet hose
View all Haier HWM110-0566 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Install the water inlet hose Confirm the water faucet Water faucet,suitable Outlet end surface Water faucet,not suitable >10mm It is required that the front end shall be longer than 10mm. The exit end face of the faucet shall be flat and smooth. If not please file it to avoid leakage. Connection between the water inlet hose jointer and the water faucet 1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1. 2. Loosen the screw till the water faucet can be accessed. Put the jointer of the water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and the jointer can not be set on the water faucet, please loosen the four screws and take out the bushing in the jointer. The front end of the faucet must be smooth, otherwise it may leak water. See to Figure 3.) water inlet hose jointer Slider Screw Lock level Screw knife Sign plate Bushing water inlet hose Figure 1 Figure 2 Figure 3 3.Fasten the four screws evenly. See to Figure 4. 4 Take off the nameplate. Twist the fastening nut as per the indication of the figure to seal up the exit end face of the faucet. See to Figure 5. remark: Before installation, the threading is 4mmabove the upper surface of the nut. After installation, the threading is 2mm above the upper surface of the nut. See to figure 6. About 4mm before twisting About less than 2mm after twisting Figure 4 Screw nut Figure 5 Figure 6 Reserve, remain time digitron It displays "--" during detecting. It displays remained reserve time (hour). It displays total remained time (min). If the total time exceeds 99 minutes, it uses "A" on tens digit to represent100 minutes, and uses "b" to represent 110 minutes. E.g. "A3" represents 103 minutes. It displays abnormal symbol in abnormal situation. (See to Page15) Soak Wash Rinse Spin Standard Heavy Soft wash Quick wash Tub dry "Power" button Push the "power" button to switch on the power. Under power-on mode, push it to switch off the power. Push the "power" button to switch on the power. If the "start/pause" button is not pushed, the machine will switch off the power automatically after 5 minutes. Process "Process"button With it you can select one or several processes of soak, wash, rinse and spin. "Program" button Following full-auto program is available Program Application Standard Common washing Heavy Washing for coverlet, bigger ,heavy thickness laundries Soft wash Washing for silk textiles slap-up laundries Quick wash 10 min quick wash for little clothes Avoid growing mildew on the Tub dry outer tub and the inner tub