Haier HWM55-33W User Manual - Page 11

Cleaning the lint filter The lint filter must be used during washing. It must be cleaned in time after each using. 1. Take off the lint filter Put hand at the indicated position. Push down to take it off. (See to Figure 1) 2. Clean the lint Put it in water and clean while it is still wet.(See to Figure 2) 3. Install the lint filter After cleaning, insert the bottom of the lint filter (marked with "down side") into the filter frame, then push the upper part of the filter in (marked with "up side"). (See to Figure 3) Figure 2 Attention: be sure not to confuse the direction. Figure 1 Figure 3 Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty. Do not wash it directly by water. Petrol Thinner Alcohol After washing, dismount the water inlet hose. Pull off the power plug and hang up the power cord. Do not store water in the tub for long period. Discharge the water immediately after each using. Wipe off the water drops on the surface and inside the tub with clean soft cloth. Open the cover of the wash tub for some time (about one hour), then close it. Hang up the drain hose. Trouble-shooting The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. Phenomena The washing machine does not act The drainage does not work. There's abnormal sound inside the machine. How to check Is there power failure? Is the power plug inserted tightly? Is the drain hose put down? Is the drain hose frozen? Is the front end of the drain hose blocked? Is the machine slanting? Is there metal item inside the tub? 9