Haier HWM62-0566 User Manual - Page 17
Trouble-shooting Answer, to question
View all Haier HWM62-0566 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomenan The digitron displays E0. The drainage cannot work, or is too slow. The digitron displays E1. The reason The top lid is opened during reserve procedure. Is the drain hose put down? Is the drain hose blocked? It stops running in midway. The digitron displays E2. The safety switch acts, and the spinning cannot work. Amend twice automatically ,The digitron displays E3. The top lid is not closed. Are the laundries put slantingly? Is the machine slanting? How to settle Close the top lid. Put down the drain hose. Open and close the top lid once. Clean the foreign material. Open and close the top lid once. Close the top lid. Reorder the laundries. Close the top lid. Placed the machine horizontally, open and close the top lid once. The water filling does not work, or is slow. The digital displays E4. Is the water tap opened, or is there water supply failure? Is the water inlet valve blocked? Is the water pressure too low? Open the water tap. Open and close the top lid once. Clean the water inlet valve then open and close the top lid once. Use after the water pressure is normal. The digitron displays E6. The machine does not act Not wash Not spin The water level sensor is bad. Is there power failure? Is the power plug inserted tightly? Is the water level reached preset position? Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Please contact the after-sales service department. Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Insert the power plug tightly. Close the top lid. Set the laundries flat. There's abnormal sound inside the machine The water tap leaks Common phenomena Phenomena Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? Is the screw of the jointer of water inlet hose loose or awry? Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. Fasten the screw of the jointer properly. Explanation The spinning is intermittent when it starts. Push the "spin" button to select "Spin", but it doesn't work. There may be some water flowing out of the drain hose in the first use of the machine. The wash procedure is paused The pulsator pauses during water inlet in wash and rinse. When the power plug is inserted, computer board indicator is switched on, and the machine starts working Balance the laundries to avoid slanting. The program is setting the drain time. Some time is needed before it starts spinning. It is the water remained in the factory inspection of performance. The cloth sensor is checking the cloth, it will add water after 48 seconds. It is to avoid splashing during water inlet. It is the special resume function. In the case of power failure or the power plug is loose during washing, the machine can save the running program, and resume the program after the power supply is recovered. You do not need to set the program again. 15