Haier HWM80-0528 User Manual - Page 16

Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself. Phenomenan The digitron displays E0. The reason Is the drain hose blocked? How to settle Close the top lid. The drainage cannot work, or is too slow. The digitron displays E1. It stops running in midway. The digitron displays E2. The safety switch acts, and the spinning cannot work. The digitron displays E3. The water filling does not work, or is slow. After stated time later, the digital displays E4. The top lid is opened during reserve procedure. The top lid is not closed. Are the laundries put slantingly? Is the machine slanting? Is the water tap opened, or is there water supply failure? Is the water inlet valve blocked? Is the water pressure too low? The digitron displays E6. The machine Not wash does not act The water level sensor is bIsadth. ere power failure? Is the power plug inserted tightly? Is the water level reached preset position? Not spin Is the power plug inserted tightly? Is the top lid closed reliably? Are the laundries set flat? Clean the foreign material. Open and close the top Lid Once. Close the top lid. Reorder the laundries. Close the top lid. Open and close the top lid after being placed horizontally. Open the water tap,then open and close the top lid once. Clean the water inlet valve, then open and close the top lid once. Use after water pressure is normall. Please contact the after-sales service department. Please use it when there's power supply. Insert the power plug tightly. Fill water to the preset position. Insert the power plug tightly. Close the top lid. Set the laundries flat. There's abnormal sound inside the machine The water tap leaks Is the machine slanting? Are the laundries put slantingly in spinning? Are there any foreign materials? Is the screw of the jointer of water inlet hose loose or awry? Adjust the machine to be even Reorder the laundries and close the top lid. Remove the foreign materials. Fasten the screw of the jointer properly. Common phenomena Phenomena Explanation The spinning is intermittent when it starts. Balance the laundries to avoid slanting. The wash procedure pauses. Select spin program, but it does not work. There may be some water flowing out of the drain hose in the first use of the machine. The cloth sensor is detecting , it will add water after about 48 seconds. The program is setting the drain time , certain period is needed before it starts spinning. It is the water remained performance inspection by the factory. 14