Haier HWM80-27S User Manual - Page 10

Twin-tub Washing Machine Adjust the tension of the belt Loosen the fastening screw at the back of the base frame. Move the shift fixing gasket along the direction indicated in the figure to adjust the tension of the belt. After adjusting, fasten the screw. (Figure11) Model:HWM80-27S Dismantling and installation of the base frame Dismantle the back cover. Loosen the wires. Loosen the fastening screw of the spin tub shaft. Separate the shaft from the brake wheel. Loosen the brake hook. Take off the brake cable frame from the installation groove of the twin-tub. Take off the V-belt. Take out the drain hose from the groove of the base frame. Loosen the fastening screw between the base frame and the cabinet to dismantle the base frame component. Screw Figure 11 Dismantling and installation of the bearing seat Once the bearing seat is taken off, it can not be utilized again. Therefore do not dismantle it as far as possible. In case that it has to be replaced, please dismantle it as per following sequence, then install a new bearing seat. Dismantle the spin tub as page 9. Then pull out the bearing seat. Cut off the inner lining claw inside the bearing seat with cutting pliers and take it out. Install the new bearing seat and inner lining. The bearing seat is an inlay component. Be sure to aim the claw of the inner lining at the hole of the tub then push it in. Please use suitable tools and add even pressure around the tub. After inlay the bearing seat, check if the claw is installed to proper position from the outside of the twin-tub (Figure 12). Right Wrong Figure 12