Haier HWM80-50 User Manual - Page 10

6 Close the top lid

7 Finish washing

8 Disposal after washing

The pulsator stops rotating.

Put down the drain hose

to discharge the water.

After using, please clean the lint and foreign materials

of the lint filter and lint frame in time.

Otherwise

it

may

influence

your

using

the

machine.

Please first

pull

off

the

power

plug

from

the

receptacle

before

cleaning.

Figure 2

Figure 3

Figure 1

Thinner

Alcohol

Petrol

1. Take off the lint filter

Put hand at the indicated position.

Push down to take it off. (See to

Figure 1)

2. Clean the lint

Put it in water and clean while it is still

wet.(See to Figure 2)

Attention: be sure not to confuse the direction.

Wipe

the complete

unit with soft cloth

twisted dry.

Wipe with neutral detergent if too dirty.

After washing, dismount the water inlet hose.

Pull

off

the

power

plug

and

hang

up the

power cord.

Do not store water in the tub for long period.

Discharge the water immediately after each

using.

Wipe off the water drops on the surface and

inside the tub with clean soft cloth. Open the

cover of the wash tub

for some time

(about

one hour), then

close

it.

Hang up the drain hose.

Do not wash it directly by water.

3. Install the lint filter

After

cleaning,

insert

the

bottom

of

the

lint

filter (marked

with "down side")

into

the

filter

frame,

then

push

the

upper

part

of

the

filter in (marked with

"up side").

(See to Figure 3)

The lint filter must be used during washing.

It must be cleaned in time after each using.

Cleaning the lint filter

Using process

Using process

Haier HWM80-50 User Manual - Page 10

Close the top lid, Finish washing, Disposal after washing

Page 10 highlights