Haier HWM90-0566 User Manual - Page 7

b Steps of using the operation buttons and description of the steps • •• Standard Normal Tub dry • • Fibre Quick • • Cotton Posthaste • • Woollen Jean • Soak Tub dry Power 6 Wash Rinse Spin Reserve Wleavteerl Program 5 1.Push "power" button to switch on the power Power 2.Push "program" button to select suitable full-auto program Program After the power is switched on, "normal"is automatically set. To select other full-auto program, please push the "program" button till the corresponding indicator is on. Refer to the "Program button" on Page 11. E.g. Set to "Quick wash" program for small quantity of laundries with light soil. Push the "SOAK", "WASH", "RINSE" OR "SPIN" button to select suitable procedure. Soak Wash Rinse Spin After switching on the power, the washing machine will set to common program including"wash, rinse, spin "automatically. To select other procedures, push the "SOAK", " WASH", " RINSE" or "SPIN" button to select the time of soak, wash and spin, and the times of rinse. After switching on the power, if you push one of the button among "WASH", "RINSE"and"SPIN", the digitron of the former procedures will turn off automatically. The former procedures will not run. For instance: after switching on the power. If you push the "SPIN"button first, it will execute spin singly after starting. 12 How to change the direction of the drain hose 1.Dismantle the rear cover of the washing machine. 3.Dismantle the drain outlet protecting cover at the other side, (the way is the same as the drain bushing),then install the drain 2.Put down the drain hose Take off the drain hose bushing, as indicated in Figure 4. frame as indicated in Figure 1.Take the drain hose into the cabinet then nip the drain fixing clamp to make it deviated from the clip the other hand is used to put down the drain bushing as indicated in Figure 2 3. 4.Extend the drain hose from the other side. Fix the drain hose with drain hose frame onto the cabinet, as indicated in Figure 5. drain outlet protecting cover Drain hose Drain hose support Figure 1 Cabinet Inner Outer Push Drain bushing Figure 2 Drain bushing Figure 4 Figure 5 Drain bushing 5.Install the drain outlet protecting cover to the other side, as indicated in Figure 6 Drain hose fixing clamp Push Take down Figure 3 Figure 6 Remarks: in order to make sure of the correct of installation, it is suggested to change the direction of the drain hose with our company serviceman . Usage the drain hose The drainage shall be smooth with the drain hose. 1.The height of the drain hose shall be less than 10cm, 4.If extra drain hose is needed, please make separate or the drainage will not be smooth, and cost such long purchase. The inner diameter of the extra hose shall time that the machine may stop at mid way. not less than 30mm, and the length shall not exceed 2.Do not step on or press the drain hose. 1.5m. 3. If the drain hose is too long, cut it at mid point. To make 5.If the extra hose is too long, cut it either at A or at B. smooth drainage, cut the front end of the hose slantingly. 5