Haier LT32R3A User Manual - Page 9

About your LCD TV / Getting Started B Press the SOURCE button to select SCART mode. C Press the PLAY button on the external device. HDMI INPUT A Connect the cable from the HDMI device to the TV HDMI socket. B Press the SOURCE button to select HDMI mode. C Refer to the HDMI device user guide for how to operate. MOUNT YOUR TV ONTO THE WALL You can mount your TV onto the wall by using a wall bracket (not supplied). Use M4/M6 machine screws (4 pcs) to screw the TV onto the bracket (not supplied). PREPARATION OF YOUR REMOTE CONTROL BATTERY INSTALLATION A Place the remote control face down, then open the cover of the battery compartment. B Install two AAA batteries. (The + and - symbol of the battery must match with the marks on the remote). C Close the cover of the battery compartment. BATTERY CAUTION Confirm there is no object between the remote control and the remote sensor of the TV set. Sunshine or other strong light will interfere with the signal sent by the remote control. In this situation turn the TV set to avoid the direct light source. Do not put the remote control in direct heat or in a damp place as you may damage the remote. Please use two AAA 1.5V batteries. Do not mix battery types. Install the batteries at the correct polarities. Do not use rechargeable batteries. If your TV is to be stored for a period of time, remove the batteries from the remote control. Getting Started Setting up LOCATION You will need to place your TV near your plug socket (so the power cable can comfortably reach) and within reach of your aerial socket or extension lead. CONNECTION A Insert your TV aerial lead into the Antenna input at the side of the TV. B Insert the batteries into the remote control. Make sure they are inserted the right way around, matching the polarity as indicated inside the battery compartment. EN-9 Digital LCD Television Instruction Manual