Haier QDHR50LZ Installation Instructions - Page 8

ENGLISH USING THE DEHUMIDIFIER Always make sure the water bucket is locked into place on the dehumidifier. Removing Collected Water There are 2 ways to remove collected water: Use the bucket. When the bucket is removed, the unit will shut off. Empty and replace the bucket. Use a hose. Water can be automatically emptied into a floor drain by attaching a garden water hose (not included). 1. Remove the bucket from the front of the unit. 2. Open the drain cover on the side of the unit. IMPORTANT: Do not use the hose if using the bucket to collect water. When the hose is connected, water will flow through it onto the floor instead of into the bucket. 3. Thread a garden hose (not supplied) onto the nozzle and ensure it is seated securely. Cut to length and lead it to the floor drain. NOTES: • Do not remove the bucket while the dehumidifier is operating or if it has just stopped operating. This might cause some water to drip from the drain pan. • The bucket must be in place and securely seated for the dehumidifier to operate. 4. Replace the bucket in the unit. NOTE: The bucket must be in place and securely seated for the dehumidifier to operate. The drain hose must run down from the dehumidifier to the floor drain. Water Level The dehumidifier will turn off automatically when the bucket is full, or when the bucket is removed or not replaced in the proper position. The bucket must be replaced in the proper position for the dehumidifier to work. The empty indicator will blink and the dehumidifier will not run if the bucket is not in the proper position. Bucket Operation DO NOT remove the foam piece and magnet block in the bucket assembly. If removed the Dehumidifier will not work properly. 8 49-5000430 Rev. 3