Haier WQP12-EFMSA User Manual - Page 10

Cleaning and Special Maintenance Filter Assembly For best performance and results, the filter assembly must be cleaned. The filter efficiently removes food particles from the wash water, allowing it to be recirculated during the cycle.For this reason ,it is a good idea to remove the larger food particles trapped in the filter after each wash cycle by rinsing the"A"semi-circular filter and cup under running water.To remove the filter assembly,pull on the cup handle in the upward direction. The entire filter assembly (made up of the "A" semicircular filter and the"B" fine filter)should be cleaned at ;east once a month.To clean the filter and the fine filter,use a cleaning brush .Then,reassemble the filter parts as shown in the figures below and reinsert the entire aseembly in the dishwasher,positioning in its seat and pressing downward. The dishwasher must never be used without the filters.Improper replacement of the filters may reduce level of the appliance and damage dishes and utensils. Cleaning the Spray Arms It may happen that food particle become encrusted on the sprayer arms and block the hole (see "Close up view [interior]",letters CF ).Check the sprayer arms periodically and clean them when needed. A B Troubleshooting It may occur that the dishwasher does not function or dows not function properly.Before calling for assistance,Iet us see what can be done first:have you forgot to press one of the buttons or to perfom an essential operation? The Dishwasher Does Not Start Have you checked whether: - the plug is pushed into the socket correctly; - the power is on in the house; - the door is closed properly; - the ON-OFF switch is on "ON"; - the water supply is turned on. The Dishwasher Does Not Load Water Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. The Dishes Are Not Clean Have you checked whether: - the water is turned on and the hose is connected properly; - the water supply to the house on and has sufficient pressure; - the water supply hose is crimped or bent; - the filter for the water supply hose is clogged. The Dishwasher Does Not Drain Have you checked whether: - the drain hose is crimped or bent. Lime Deposits or a White Film Form on the Dishes Have you checked whether: - the lid to the salt container is closed properly; - the rinse aid dosage is correct. If,despiste all these checks,the dishwasher still does not function and/or the problem persists,contact the nearest authorised service centre and provide them with the following information: - the nature of the problem; - the model type number (Mod...)and the serial number (S/N...), which are indicated on the plate located on the side of the inner part of the door. Never call on unauthorised technicians and refuse to allow parts to be installed that are not original spare parts. .9. GB