Hamilton Beach 05521 Use And Care - Page 15

840115700 Ev00.qxd 6/6/03 8:59 AM Page 15 The Filler Cap Is Difficult to Remove • Sometimes a vacuum can form in the tank, especially if it has not been seated on the base for a long period of Press here time. Press the button in the center of the filler cap to relieve the vacuum. • Apply 100% pure petroleum jelly to the filler cap gasket. Wipe off any excess. Fan Enclosure or Tank Does Not Fit on Base • Make sure that the cord or other objects are not trapped under the fan enclosure or tank. • New filters are shipped flat and must be "rounded" before installation. Gently pull the filter into a round shape, being careful not to tear it. Once the filter is properly rounded, install it and lower the fan enclosure into place (as described on page 6). • Is the cord routed correctly? The cord should be pressed Cord behind tabs completely into the cord exit notch. Any excess Cord exit notch cord should be completely behind the tabs in the cord storage compartment, as shown above. New filter Rounded filter 15