Hamilton Beach 14955 Use & Care - Page 3

Save These Instructions

Page 3 highlights

16. When blending hot liquids, remove filler-cap of two-piece lid and close the edge cover opening intended for pouring. To prevent possible burns: Do not exceed the 3-cup (709.8-ml) level. Hot liquids may push off two-piece lid during blending; therefore, with the protection of an oven mitt or thick towel, place one hand on top of the lid, keep exposed skin away from the lid, and start blending at lowest speed. 17. Ensure collar on base of blender jar is tight and secure. Injury can result if moving blades accidentally become exposed. 18. If the jar should twist or rotate when the motor is switched ON, switch O (OFF) immediately and tighten jar in collar or on blender base. 19. Do not leave blender unattended while it is operating. 20. To disconnect cord, turn the control to O (OFF). Then remove plug from wall outlet. 21. Do not use appliance for other than intended purpose. SAVE THESE INSTRUCTIONS! Other Consumer Safety Information This appliance is intended for household use only. WARNING! Shock Hazard: This appliance has a polarized plug (one wide blade) that reduces the risk of electric shock. The plug fits only one way into a polarized outlet. Do not defeat the safety purpose of the plug by modifying the plug in any way or by using an adapter. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, have an electrician replace the outlet. The length of the cord used on this appliance was selected to reduce the hazards of becoming tangled in or tripping over a longer cord. If a longer cord is necessary, an approved extension cord may be used. The electrical rating of the extension cord must be equal to or greater than the rating of the appliance. Care must be taken to arrange the extension cord so that it will not drape over the countertop or tabletop where it can be pulled on by children or accidentally tripped over. 3 840230700 ENv03.indd 3 6/28/13 9:59 AM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24

3
16.
When blending hot liquids, remove filler-cap of two-piece lid and
close the edge cover opening intended for pouring. To prevent
possible burns: Do not exceed the 3-cup (709.8-ml) level. Hot
liquids may push off two-piece lid during blending; therefore, with
the protection of an oven mitt or thick towel, place one hand on
top of the lid, keep exposed skin away from the lid, and start
blending at lowest speed.
17.
Ensure collar on base of blender jar is tight and secure. Injury
can result if moving blades accidentally become exposed.
18.
If the jar should twist or rotate when the motor is switched ON,
switch
O
(OFF) immediately and tighten jar in collar or on blender
base.
19.
Do not leave blender unattended while it is operating.
20.
To disconnect cord, turn the control to
O
(OFF). Then remove
plug from wall outlet.
21.
Do not use appliance for other than intended purpose.
SAVE THESE INSTRUCTIONS!
This appliance is intended for household use only.
WARNING!
Shock Hazard: This appliance has a polarized plug (one
wide blade) that reduces the risk of electric shock. The plug fits only
one way into a polarized outlet. Do not defeat the safety purpose of
the plug by modifying the plug in any way or by using an adapter. If
the plug does not fit fully into the outlet, reverse the plug. If it still
does not fit, have an electrician replace the outlet.
The length of the cord used on this appliance was selected to
reduce the hazards of becoming tangled in or tripping over a longer
cord. If a longer cord is necessary, an approved extension cord
may be used. The electrical rating of the extension cord must be
equal to or greater than the rating of the appliance. Care must be
taken to arrange the extension cord so that it will not drape over
the countertop or tabletop where it can be pulled on by children or
accidentally tripped over.
Other Consumer Safety Information
840230700 ENv03.indd 3
840230700 ENv03.indd
3
6/28/13 9:59 AM
6/28/13
9:59 AM