Hamilton Beach 54615C Use & Care - Page 7

840155503 ENv01.qxd:840153700 ENv01.qxd 7/9/10 8:37 AM Page 7 Optional Cleaning 1. Remove dispenser assembly cap by rotating counterclockwise. 2. Wash dispenser and parts in hot, soapy water. Rinse and dry thoroughly. Do not soak. NOTE: Do not remove seal rings from adaptor. 3. Reassemble plunger inside of dispenser body and rotate cap clockwise until tight. Dispenser Assembly Cap Plunger Dispenser Assembly Body Adaptor Seal Rings Troubleshooting PROBLEM Blender leaks. PROBABLE CAUSE • Tighten cutting assembly on jar. • Make sure gasket is in place on cutting assembly. • Make sure gasket is not damaged. If damaged, please call our toll-free customer service number to order a replacement. • Make sure lid with filler cap is pushed down tightly on jar. Ice not crushed. • See ice crushing instructions in "Blending Specific Foods" section. Does not blend well. • Make sure enough liquid has been added. A minimum of 10 ounces (300 ml) is recommended. Does not dispense. • Make sure blender is ON. Dispenser leaks. • Make sure seal rings are in place on dispenser adapter. • Tighten dispenser cap (located above dispenser body). Cannot remove cutting assembly. • Loosen collar by holding jar and turning cutting assembly counterclockwise. 7