Hamilton Beach HBB908 Operation Manual - Page 9
Troubleshooting Guide, Replacement Parts for Model HBH908, Maintenance - 6126
UPC - 040094910939
View all Hamilton Beach HBB908 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Caring for the Blender Troubleshooting Guide Problem . . . Blender fails to start or stops while it is running and cannot be restarted Solution . . . • Check to see if unit is securely plugged into an electric outlet. • Check to see if the fuse for the electric outlet has blown or if a circuit breaker has tripped. Ingredients will not mix properly • Check to see if enough liquid has been added to the ingredients. Mixture should be fluid and free-running at all times. • Solid pieces are too large. Pieces should not exceed 1″ (25mm)cubes. • Container is too full. Do not fill past highest graduation marking. • Cutter unit blades are not sharp or are damaged. Inspect container and cutter assembly daily. Replace cutter assembly at least every 90 days or sooner if cutter assembly appears worn or damaged. • Check to see if cutter assembly is installed properly. • Select speed to create a fluid blend. Maintenance Inspect the blender and its various parts and replace as follows: Daily Weekly Quarterly Unplug the blender and remove the container from the base, and then inspect the container and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary. If the blades are loose, discontinue use immediately and replace the blades. Do not attempt to repair or tighten the cutter assembly. See "Replacement Parts" below. Unplug the blender, and then inspect the power cord insulation and power plug for cracks. Refer to "Technical Service" for repair or replacement. Replace the container and cutter assembly at least every 90 days. See "Replacement Parts" below. Replacement Parts for Model HBH908 For replacement parts, call toll free: 866-285-1087. Part Description 44 oz. polycarbonate container Cutter assembly Part Number 6126-HBB908 HBB99100 9