Harbor Freight Tools 61694 User Manual - Page 13

Safety Setup Loading the Tool TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING: • Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields. • Release the Trigger. • Detach the air supply. • Attempt to fire the tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners. 1. Depress the Magazine Latch and pull back on the Moveable Magazine, sliding it back to end of Fixed Magazine. Note: This Nailer/Stapler can drive 16 Gauge Finish Nails, 18 Gauge Brad Nails and Staples. The various type of fasteners are loaded in different ways. 4. To load Staples, insert staples from the top area of the Fixed Magazine with one arm of the staples in the center slot and the other arm along the Fixed Magazine's left side. Refer to Figure E. FIG . 7 2. To load 18 Gauge Brad Nails, insert the nails into the channel along the right-side of the Fixed Magazine. Refer to Figure C. FIG . 8 Staples Fixed Magazine 18 Gauge Brad Nails Figure C 3. To load 16 Gauge Finish Nails, insert the nails into the channel along the left-side of the Fixed Magazine. Refer to Figure D. FIG . 6 Figure E 5. After the nails or staples are loaded, slide the Moveable Magazine back into the Fixed Magazine until the Magazine Latch snaps back in place, securing the Moveable Magazine and locking the fasteners into place. Operation Maintenance 16 Gauge Finish Nails Figure D Item 61694 For technical questions, please call 1-888-866-5797. Page 13