Harbor Freight Tools 62687 User Manual - Page 10
Tool Set Up: Chisel Installation
View all Harbor Freight Tools 62687 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Safety Operating Instructions Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Inspect tool before use, looking for damaged, loose, and missing parts. If any problems are found, do not use tool until repaired. Tool Set Up: Chisel Installation TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the switch to its off position before performing any inspection, maintenance, or cleaning procedures. TO PREVENT SERIOUS INJURY: Do not adjust or tamper with any control or component in a way not specifically explained within this manual. Improper adjustment can result in tool failure or other serious hazards. TO PREVENT INJURY: Wear heavy-duty work gloves during Chisel installation. 1. Place the air intake end of the tool on a clean surface on the floor. This will prevent debris from entering into the air intake. 2. Pull down on Collar (24), making sure to keep the open end of Retaining Ring (25) between your thumb and index finger to prevent pinching. 3. Position end of the Chisel (26) into Chisel Holder (19) and rotate Chisel until it slides in. See Figure C. Chisel (26) Setup Operation Maintenance Page 10 Chisel Holder (19) Collar (24) Figure C 4. Release the Collar to lock Chisel in place. For technical questions, please call 1-888-866-5797. Item 62687