Harbor Freight Tools 67450 User Manual - Page 14
Loading the Tool
View all Harbor Freight Tools 67450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
SAFETY Loading the Tool TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION, BEFORE LOADING: • Wear ANSI-approved safety goggles with side shields. Other people in the work area must also wear ANSI-approved impact safety goggles with side shields. • Release the trigger. • Detach the air supply. • Attempt to fire the Tool into a piece of scrap wood to ensure that it is disconnected and is incapable of firing any fasteners. 1. Push down on the Latch (68) and swing the Catch (64) and the Canister Cover (89) open. 3. Turn the Adjuster Nut (88) clockwise to raise the Adjuster Plate (86) until its edge aligns with the embossed nail size markings on the inside wall of the Canister. Latch (68) Catch (64) 4. Place a coil of Nails around the Adjuster Plate (86) in the Nail Canister (82). Canister Cover (89) Canister Cover (89) Canister (82) 2. Check the Adjuster Plate (86) inside the Canister (82). Rotate the Adjuster Nut (88) to adjust the Platform to match the nail length: A. Between 3/4″ and 1″ Long Nails (Use top setting). B. Between 1″ and 1-1/4″ Long Nails (Use middle setting). C. Between 1-1/4″ and 1-3/4″ Long Nails (Use bottom setting). Feed Hook (50) Nails Canister (82) Adjuster Plate (86) 5. Swing the Canister Cover (89) closed. 6. Close the Catch (64). Make sure the Latch closes securely. If it does not engage, the nail head is not in the slot in the upper portion of the Feed Hook (50) and nail shank is not in the feeder. SETUP OPERATION MAINTENANCE Page 14 For technical questions, please call 1-800-444-3353. Item 67450