Harbor Freight Tools 95082 User Manual - Page 9

5. Place Rubber Cap (5) on the Handle dust bag is emptied frequently to and tighten Bolt (6) into the Right Cap prevent clogging. (11). WARNING: ENSURE DUST BAG 6. Using a screwdriver (not included), IS EMPTIED FREQUENTLY. fasten the two Cord Wrap Frames REDUCED FLOW CAN CAUSE (29) to the Side Cover (30) using four WOOD CHIPS TO CLOG AND Screws (28). See Figure B. BREAK EXHAUST FAN. FOR BEST RESULTS, USE VACUUM SYSTEM Cord Wrap Frames (29) INSTEAD OF DUST BAG. 9. WARNING! Make sure Blade Screws is fastened and tightened down (28) securely before beginning any work. Refer to "Changing Cutting Blades" section of this manual to tighten blade properly). Side Cover (30) Operating Instructions Figure B 7. Use included Hex Wrench (122) to loosen Head Screw (79) on the frame of the Dust Chute (80). Slide Dust Chute over Fan Housing (78). Fasten Dust Chute in place by tightening Head Screw. See Figure C. Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. Tool Set Up Dust Chute (80) Fan Housing (78) Figure C Hex Wrench (122) Head Screw (79) To prevent serious injury from accidental operation: Turn the Power Switch of the tool to its "OFF" position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures. 8. A dust collection bag can be attached Work Piece and Work Area Set Up to the dust Chute to collect wood 1. Designate a work area that is clean chips, however it is critical to ensure and well-lit. The work area must not SKU 95082 Rev 10d, 10k For technical questions, please call 1-800-444-3353. Page 9