Harman Kardon AVR300 Owners Manual - Page 29
Reassigning Device-Control, Selectors
View all Harman Kardon AVR300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Programming the Remote the remote for Volume Punch-Through, follow these steps: 1. Press the Input or Video Device Selector c 35 for the unit you wish to have associated with the volume control and the Mute button 31 at the same time until the red light illuminates under the Device Selector. 2. Press the Volume Up button 32 . 3. Press either the AVR b or the TV Device Control Selector 35 , depending on which system's volume control you wish to have attached for the punch-through mode. Note that the red light under the Device Control Selector 35 will blink twice and then go out to confirm the data entry. Example: To have the AVR's volume control activated even though the remote is set to control the TV, first press the TV Device Control Selector 35 and the Mute button 31 at the same time. Next, press the Volume Up button 32 , followed by the AVR Device Control Selector b. NOTE: Should you wish to return the remote to the original configuration after entering a Volume Punch-Through, you will need to repeat the steps shown above. However, press the same Device Control Selector in steps one and three. Reassigning Device-Control Selectors Although any of the Input or Video Device Selectors c 35 is normally assigned to the category of product shown on the remote, it is possible to reassign one of these buttons to operate a second device of another type. For example, if you have two VCRs but no cable box receiver, you may program the CBL button 35 to operate a second VCR. Before following the normal programming steps for either Three-Digit entry or Auto Search code entry, you must first reassign the button with the following steps: 1. Press the Input or Video Device Selector c 35 you wish to reassign and the Mute button 31 at the same time until the red light illuminates under the Device Control Selector 35 . 2. Press the Input or Video Device Selector c 35 for the function you wish to program into the reassigned button. 3. Enter the three-digit code for the specific model you wish the reassigned button to operate. 4. Press the same Input or Video Device Selector c 35 pressed in Step 1 once again to store the selection. Example: To use the CBL button to operate a second VCR, first press the CBL Device Control Selector 35 and the Mute button 31 at the same time until the red light glows under the CBL button. Press the VCR button, followed by the three-digit code for the specific model you wish to control. Finally, press the CBL button again. 1 3 4 2 5 6 7 8 9 10 11 12 13 14 15 16 18 17 19 20 21 23 22 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 AVR 300 29 PROGRAMMING THE REMOTE