Harman Kardon AVR70 Owners Manual - Page 28
Screen, Display, Select
View all Harman Kardon AVR70 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
On Screen Display 22 r Master Volume When the volume is changed, a horizontal scale will briefly appear at the bottom of the screen with the volume level. (Figure #8) MASTER VOLUME 1111111111111 1111111 111111H -- Figure 8 Mute When the unit is placed in audio mute, the word MUTE will appear in the upper right comer of the screen as a reminder that the volume has been cut. (Figure #9) MUTE On Screen Display Function If you do not wish to have the on screen displays appear, press and hold the SCREEN DISPLAY button m on the remote for three seconds. A reminder message will appear on the screen for a few seconds (Figure #10), and the displays will then be canceled until they are once again activated. Using The On Screen Menus for System Control Besides conveying status messages, the on screen display system may also be used as a means of controlling the opera- tion of the unit. To operate the control system. always start by pressing SELECT C) on the remote to bring up the Main Menu. (Figure #1). Then, use the up/down navigational arrow keys A and V 411) to move the cursor. Press SELECT fir) to choose a menu, and then use the left/right navigational arrow keys 1 and to view the choices in that current option. Finally when the desired choice appears, press SELECT (I) to enter the choice and return to the MAIN MENU. To exit from the Menu Control System, press Ir 411) until the on screen > cursor is pointing to MENU OFF and press SELECT C). The following functions of the AVR70 may be controlled through the Menu Control System: INPUT SELECTION: After reaching the INPUT SELECTOR menu (Figure #11), use the arrow keys on the m remote to select the desired input. Remember that when a split listening session is desired, select the VIDEO source first, followed by the AUDIO source. SURROUND MODE: After reaching the SURROUND MODE menu (Figure #12), use the navigational arrows 405, to select the desired mode. When a mode is selected that uses the surround channels. you may change the rear channel DELAY TIME at this menu. TEST TONE: At this menu you may adjust the speaker output levels. For information on this procedure, refer to the System Configuration section of this Manual. SET UP MENU: For information on using the Set Up menu, refer to the System Configuration section of this Manual. Figure 9 ON SCREEN DISPLAY -OFF- 1 Figure 10 INPUT SELECTOR >AUDIO *LI)* VIDEO *LD* TAPE MONITOR ON OFF RETURN TO MAIN MENU Figure 11 SURROUND MODE >MODE : PRO LOGIC DELAY TIME : 20ms RETURN TO MAIN MENU Figure 12