Harman Kardon AVR7000 Owners Manual - Page 17
Installation And Connections - avr 7000 a v receiver
View all Harman Kardon AVR7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation and Connections External Audio Power Amplifier Connections If desired, the AVR 7000 may be connected to optional, external audio power amplifiers or used with equalizers or speaker systems that require connection between the preamp and amplifier sections of a receiver. To make these connections, remove the jumpers that connect the Preamp Out jacks fl and Amplifier In jacks ⁄ for the channels to be used with external devices. Store the jumpers in a safe place so that the AVR may be used in its normal mode at a future date, if desired. When an external amplifier is used, connect the Preamp Out jacks fl to the inputs on the amplifier. When an equalizer or speaker processor is used, connect the Preamp Out jacks fl to the inputs of the processor, and connect the outputs of the processor back to the Amplifier In jacks ⁄ on the AVR. Note that when external amplifiers or devices are used, the volume control is still controlled by the AVR, although additional volume controls on the external device may impact the volume settings and output levels from the AVR. External Audio Decoder Connection To provide for ultimate flexibility, the AVR 7000 may be used in conjunction with optional, external decoders for digital audio systems other than the AVR 7000's own built-in Dolby Digital and DTS decoding system or with DVD players using the DVD Audio Format. If an external decoder is used, connect the output jacks of the decoder to the 6-Channel Direct inputs £, making sure to match channels. These jacks may also be used for connections to devices such as DVD players or High Definition Television (HDTV) sets or decoders that feature built-in digital surround decoders. Although the digital decoding system in the AVR 7000 will typically provide audio performance that is superior to other decoders, you may use these jacks to provide an additional 6-channel input for connection to a DVD player or HDTV set with a built-in decoder and discrete 6-channel analog outputs. AC Power Connections This unit is equipped with three accessory AC outlets. They may be used to power accessory devices, but they should not be used with highcurrent draw equipment such as power amplifiers. The total power draw to each outlet may not exceed 100 watts. The Switched ‹ outlets will receive power only when the unit is on. This is recommended for devices that have no power switch or a mechanical power switch that may be left in the "ON" position. NOTE: Many audio and video products go into a Standby mode when they are used with switched outlets, and cannot be fully turned on using the outlet alone without a remote control command. The Unswitched ¤ outlet will receive power as long as the unit is plugged into a powered AC outlet. Finally, when all connections are complete, plug the power cord into a nonswitched 120-volt AC wall outlet. You're almost ready to enjoy the AVR 7000! 17 INSTALLATION AND CONNECTIONS