Harman Kardon DVD5 Owners Manual - Page 8

Rear Panel Connections ¡™ £ ¢∞ § ¶• ª ¡ Optical Digital Output ™ Coaxial Digital Output £ Analog Audio Outputs ¢ Composite Video Output ∞ S-Video Output § Component Video Outputs ¶ Remote Control Output • Remote Control Input ª AC Power Cord ¡ Optical Digital Output: Connect this jack to the optical digital input of an A/V receiver or surround processor for Dolby Digital, DTS or PCM audio playback. ™ Coaxial Digital Output: Connect this jack to the coaxial digital input of an A/V receiver or surround processor for Dolby Digital, DTS or PCM audio playback. NOTE: The coaxial digital output should only be connected to a digital input. Even though it is the same RCA-type connector as standard analog audio connections, DO NOT connect it to a conventional analog input jack. £ Analog Audio Outputs: Connect these jacks to an audio input on an A/V receiver or surround processor for analog audio playback. ¢ Composite Video Output: Connect this jack to the video input on a television or video projector, or to a video input on an A/V receiver or processor if you are using that type of device for video input switching. ∞ S-Video Output: Connect this jack to the S-Video input on a television or video projector, or to an S-Video input on an A/V receiver or processor if you are using that type of device for S-Video input switching. § Component Video Outputs: If your TV or video projector has component video inputs, you may connect these output jacks to the set for the highest video quality available. Note that the component video inputs may be labeled as Y/Pr/Pb or Y/Cr/Cb but, for connection purposes, they are the same. The outputs of these jacks should NOT be connected to a standard composite video input. ¶ Remote Control Output: Connect this jack to the infrared (IR) input jack of another compatible Harman Kardon remote controlled product to have the built-in Remote Sensor ^ on the DVD 5 provide IR signals to other compatible products. • Remote Control Input: Connect the output of a remote infrared sensor, or the remote control output of another compatible Harman Kardon product, to this jack. This will enable the remote control to operate even when the front panel Remote Sensor ^ is blocked. This jack may also be used with compatible IR remote control-based automation systems. ª AC Power Cord: Connect this plug to an AC outlet. If the outlet is controlled by a switch, make certain that it is in the ON position. 8 REAR PANEL CONNECTIONS