Harman Kardon HK3270 Owners Manual - Page 10
Tape Monitor Play/In, Tape Monitor Record/Out, Tape 2 Play/In, Tape 2 Record/Out, Main In, Preamp
View all Harman Kardon HK3270 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Rear Panel Connections 11 ª Tape Monitor Play/In: Connect these jacks to the Play/Out jacks of an audio recorder. , Tape Monitor Record/Out: Connect these jacks to the Rec/In jacks of an audio recorder. NOTE: When these jacks are connected to a three-head recorder or another device with off-head playback, it will be possible to monitor the source being recorded. ⁄ Tape 2 Play/In: Connect these jacks to the PLAY/OUT jacks of a second audio recorder. Tape 2 Record/Out: Connect these jacks to the Rec/In jacks of a second audio recorder. ‹ Main In: These jacks are the input to the HK3270's power amplifier. Unless an external power amplifier is used, the jumper pins should remain connected to the Preamp Out jacks ›. › Preamp Out: These jacks proved an output for the left and right channels to an optional external amplifier. In normal operation, unless an external power amplifier is used, the jumper pins should remain connected to the Main In jacks ‹. fi Subwoofer Out: Connect these jacks to the line level input of a powered subwoofer. If an external subwoofer amplifier is used, connect this jack to the subwoofer amplifier input. fl Speaker 1 Terminals: Connect these terminals to the appropriate terminals on your speakers. ‡ Speaker 2 Terminals: Connect these terminals to the appropriate terminals on your speakers. ° Accessory Outlets: These outlets may be used to power lowcurrent draw devices such as CD players or cassette decks. Note that the power to these outlets will remain on as long as the Main Power Switch 1 is pressed in. These outlets will continue to be powered even when the unit is in the Standby mode. To remove power to these outlets, the Main Power Switch 1 must be placed in the OFF position. NOTE: The power consumption of the devices plugged into these outlets should not exceed 100 watts. · Power Cable: Connect the AC plug to a non-switched AC wall output.