Harman Kardon HKTS 11CP Owners Manual - Page 8

MOUNTING OPTIONS Wall 23mm or 3/4" Satellites and Surrounds 23mm or 3/4" (M6-1.25P or 1/4"-20) Remove Stand The satellite speakers 15mm or 1m/2a"y be placed on a shelf. They may be wallmounted using the supplied brackets. Wall-Mounting Wall Plate 15mm Unscrew the bolt that attaches theorb1l/a2c"k shelf stand to the bottom of the speaker. Store the stand and bolt in a safe place, in case they are needed for a future installation. Remove Stand Wires to Speaker Terminal Cover Wires to Speaker 23mm or 3/4" Wall (M6-1.25P or 1/4"-20) Wall Plate Terminal Cover Wall Plate Mount the wallbracket attachment Remove Stand Overhead View Wire Wall From Wall Plate plate on the wall in the desired loca- 15mm or 1/2" tion. If possible, position the Overhead speakers so that the mountVinigewscrews (not included; use size #8) may be installed directly into a wooden wall stud. If that is not possible, use optional wall Wires to Speaker anchors that are rated to support at least on top: a round screw hole, and an arc- shaped opening2W3miinrmefront of it. The speaker cable should boeFrr3ot/hm4r"eaded through the arc- Wall (M6-1.25P shaped openinPgl,anteot the scroerw1/4h"-o2l0e). Attach the bracket to the wall plate by insert- ing the tab at the top of the wall plate into the slot on top of the bracket and snapping the bracket onto the wall plate. twenty-five pouWndasl.l TPhlaetecustomer is Thread the cable through the round opening responsibRSlteeamnfodovre proper selection and uTesreminal Coverin the terminal cover, and then insert the of mounting hardware, available through speaker wires into the terminals on the 15mm or 1/2" hardware stores, to properly and safely underside of the speaker, remembering to wall-mount the speakers. observe the correct polarity (see page 9). Referring to the speaker connection instructions on pages 9 through 12, thread the appropriate speaker cable through the opening in the bottom of the wall plate, and then Wires to Speaker Overhead through the bacVkieowf the bracket, as shown in the diagram. The bracket has two openings Place the terminal cover over the opening on the underside of the speaker so that it fits flush Wire against the speaker anWd acll oPvlaeters the ter- mFroinmals, with its round opening exposing the tW Phlaarteleladed insert. The bracket fits through the round opening in the terminal cover. Terminal Cover Insert the supplied bracket bolt up through the bottom of the bracket and terminal cover, and screw it into the threaded insert on the underside of the speaker. The bolt should be snug, but not so tight as to prevent the bracket from pivoting. The wall-mounted speaker may be pivoted from side to side; however, the bracket is not designed to be tilted up or down, and attempting to tilt it will damage the bracket and possibly the wall, which would not be covered by your warranty. Wall Plate Wall 23mm or 3/4" (M6-1.25P or 1/4"-20) 8 MOUNTING OPTIONS