Harman Kardon HKTS 200 User Guide - Page 8
Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output
View all Harman Kardon HKTS 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Left Front Center Right Front Front Left Speaker Cable (White Bands) -+ Center Speaker Cable (Green Bands) -+ Front Right Speaker Cable (Red Bands) -+ +- +- +FRON-T SURROUND RIGHT LEFT +- Receiver Surround Left Speaker Cable (Blue Bands) +CENT-ER SUB LFE OUT LFE/Trigger Cable (Purple Ends) -+ Surround Right Speaker Cable (Gray Bands) PL0004-01001 Subwoofer PL0004-01001 -+ Left Surround Right Surround Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output Use this installation method for receivers and preamp/processors that have a dedicated subwoofer output with low-pass filtering (also called bass management). If the dedicated subwoofer output does not have low-pass filtering, follow the instructions in Connecting the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 9. Use the LFE (purple) connector of the supplied combination LFE and trigger cable to connect the HKTS200SUB's Line-Level LFE In Jack 5 to the dedicated subwoofer output (or LFE output) of your receiver or preamp/processor. Connect each satellite speaker and the center speaker to the corresponding speaker terminals on your receiver or amplifier. In your receiver or preamp/processor's setup menu, configure it for Subwoofer ON, and set the front left, front right, center, and surround speakers to Small. After you have made and verified all connections, plug the HKTS200SUB's AC Power Cord 8 into an active AC outlet. 8