Harman Kardon SR900 Owners Manual - Page 5
Resistor
View all Harman Kardon SR900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
CONNECTING THE SPEAKERS FOR STEREO OPERATION (2 SYSTEMS) 1. Connect all 4 speakers for your two system operation as shown in Diagram B. 2. You may now select either system 1, system 1 and 2 or system 2 by the use of the "Speaker Selector Switch" on the front panel. CONNECT SPEAKERS WITH CARE AVOID ACCIDENTAL SHORTS SYSTEM 2 DIAGRAM B SYSTEM 1 11907206492 NOTE: WHEN ALL THE SPEAKERS USED IN YOUR 2 SYSTEM CON- NECTION ARE 4 OHMS, CONNECT A 2 OHM, 10 WAIT RESISTOR IN SERIES WITH THE HOT SIDE OF EACH OF THESE SPEAKERS, (IF 'TWO OF THE SPEAKERS ARE 4 OHMS AND 2 OF THE SPEAKERS ARE ANY HIGHER IMPEDANCE THIS PRECAUTION IS NOT NECESSARY.) CONNECTING THE SPEAKERS FOR MONOPHONIC OPERATION (1 SYSTEM) If the SR900 is to he used monophonically and stereo is to he added at a later date, it is essential that both speaker output terminals are terminated into a proper load to prevent damage to the output stage of the receiver. Refer to Diagram C for proper installation of the loading resistor. At no time should the output terminals be paralleled for monophonic operation! THIS IS THE ONLY CORRECT METHOD FOR CONNECTING ONE SPEAKER TO THE SR900 CONNECT SPEAKERS WITH CARE-AVOID ACCIDENTAL SHORTS o' DIAGRAM C SYSTEM I H907206512